1. Find a convenient location to host your home game. (My church, my store, etc.) Find a place that's convenient for you and take it there. Set up a play card area and shuffle up and deal! The chairs should be square and comfortable. (My fave is length-relative-to-handbooks-recommended, who I also use at my non- denomination table games.
2. Get some nice green felt. It does not matter if it is expensive, just get some clean, soft,igee colored felt and spread it out over your card area. Spread it evenly so that it doesn't get all over your cards. If you have many cards, it can cause problems with marking. Next, search for or select poker fabric. You will pay more for better quality but it is well worth it for longer games. Genericmeter felt is more cost-friendly. Ace Duece Multicolor has yet to be used. However, it is likely that it will. A standard green is $10.00; each additional color is $1.00
3. http://fr33agents.com/pai-gow-poker-rules/ Pick out a cheap poker deck. This is more of a dollar-store decision. However, you can still find decently priced cards at your local paper store. You can buy these in nearly any size you like, much like the poker fabric. Save a little cash by only buying suited cards or higher.
4. Get your chips and cards. You can get a little cardboard for less than $1.00 if you check the price at theaids or in the paper. Cheap cards and plastic chips are also available if you're looking to save money. It doesn't matter what material you use, as long as it lasts.
5. As I have said, make sure that you get the right poker cards. Stretchedpaper (100%) is the best choice. You can start with paper, as you did with all the other articles in this article. Yes, you can use staples to trim the paper to the desired size.
6. Roll the cards out to the edges by folding them. http://samgranger.com/how-to-read-poker-tells/ This will create a raised area you can use to staple the card. You can either use a stapler or stamps depending on what you prefer. You can seal the card by placing it on the surface and trimming.
7. You will now need to trim the card's edges with a knife. Top off the card using your staples or tape.
8. Repeat the same process on the other card. After you have both cards covered up, take the paper off the card. Move it to the edge of the table, and staple it on tight (about 1/4"). Pat the card in the middle.
9. Repeat this process until all the cards you want to swap have been applied.
10. You should now have smooth poker cards. Before you move on, wipe the cards with a damp rag to restore the bounce.
11. For any spots that may have formed during application, you can use a cleaner on the cards to seal them.
12. Use a round iron to iron the cards. The bottom edge should be exposed.
13. sear both ends of the cards with a saw or a very small knife. It doesn't need be perfect. The felt will be easy to put together if you have the right idea.
14. Stamps can be used to transform the cards. If you want to make a pattern other than a straight line, or flush, stamp the opposite side. Use a glue gun. Press the felt gently until it bonds to the other side.
15. After the cards are all placed, let them soak in some water. Mix a little soap with water.
16. Once you're done, cover the cards with a clean cloth and wipe them dry. You can dry the cards with a soft cloth if you wish. You must ensure that there is no bleeding.
17. Now you can play with the cards.
Ten Steps to Set Up a Poker Room
·
3 min read
